Handmade in BodrumFree worldwide shippingHelp & FAQ

Lighting and Decor Ideas

Home Bar Lighting Ideas: Pendants, Shelves and Dimming

Home bar with three carved gourd pendants over a walnut counter and warm lit back-bar shelves

Good bar lighting ideas start with a plain fact: a bar does two jobs at once. Someone behind it needs to see a jigger line and a knife, and the people sitting in front of it want a low, warm room. One fixture can’t do both, so plan the light in zones.

This guide covers indoor bars, a home bar first and a small commercial bar second, not light bars for trucks. We make carved gourd lamps in Bodrum, Turkey, but most of what follows applies to any fixture.

Home bar lighting ideas: start with what the bar is for

Before buying anything, work out who stands behind the bar and where guests sit. A bar cart in a living room corner needs one warm lamp nearby and a small work light. A built-in counter with stools, a sink and back shelves has several lighting zones, and each is cheaper to wire during a remodel than after the drywall is painted.

Note where the outlets and switches are. Plug-in pendants and LED tape with plug-in drivers can do a lot in a rental. Anything connected into a ceiling box or wall is a job for a licensed electrician.

Bar zones and lighting options at a glance

Color temperatures below are typical warm-white choices for a bar used mostly in the evening. You won’t need every row.

ZoneFixture optionsColor temperatureNotes
Over the counter (guest side)Row of pendants, 2 to 4 over most home bars2200K-2700KBottom 30-36 in (76-91 cm) above the counter, 24-30 in (61-76 cm) apart center to center
Work area behind the barRecessed downlights, small adjustable spots, under-cabinet LED2700K-3000KOwn switch or dimmer; aim down at the work surface, away from guests
Back-bar shelvesLED tape in an aluminum channel with a diffuser, puck lights2700K-3000KCRI 90 or higher shows the color of spirits properly
Under the bar topLED tape under the front overhang or near the foot rail2200K-2700KLow output; hide the strip so guests can’t see the LED dots
Lounge corner or end of the barCluster of patterned pendants, table lamp on a side table2200K-2700KAtmosphere only; pattern lights are not task lights
Sink and ice wellDamp-rated downlight2700K-3000KWet zone; no decorative or gourd lamps directly above

Pendants over a bar counter: spacing and height

Spacing

A common guideline is 24 to 30 inches (61-76 cm) center to center. Keep the end pendants at least 12 inches (30 cm) in from each end of the counter, and leave roughly 6 inches (15 cm) of air between the edges of neighboring shades. On an 8 ft (244 cm) counter, three pendants 30 inches apart leave about 18 inches at each end.

Height

A common guideline puts the bottom of the pendant 30 to 36 inches (76-91 cm) above the counter. Bar-height counters are usually about 42 inches (107 cm) tall, higher than a 36 inch kitchen counter, so the pendants end up around 72 to 78 inches (183-198 cm) from the floor. Opinion: if someone stands behind the bar pouring, go toward the top of that range so they can see guests’ faces under the shades.

Mock it up with string and a cardboard box, then sit on a stool and stand behind the bar. Our guide on how to hang Turkish lamps covers hooks, ceiling weight and plug-in swag versus hardwiring in detail.

Our hanging gourd models come with an 80 cm (32 in) cable. In an 8 ft room over a bar-height counter that is usually more than enough, and when it is hardwired the electrician sets the final length at the canopy. At 10 ft and above it is short.

Glare for people sitting at the counter

Glare shows up only after the stools arrive. Someone on a bar stool has eyes roughly 60 inches (152 cm) from the floor, so a pendant at 72 to 78 inches sits a foot or so above their eye line and a couple of feet away. A bright exposed bulb there is in their view all evening.

  • Hide the bulb. Pick shades that cover it, or opal and frosted bulbs.
  • Use less light per pendant. Low-output pendants are easier on the eyes.
  • Watch shiny surfaces. Polished stone and epoxy bar tops mirror downlights back at guests, and a back-bar mirror doubles every pendant.
  • Aim work lights down. Point them at the work surface, never across the counter.

Carved gourd pendants hide most of the bulb inside the shell, but at some angles you can see it through a hole as a bright point. A warm LED of 4-8 W (40 W equivalent or lower) helps keep that point comfortable. Our post on what type of bulb to use in a Turkish lamp covers the details.

Close-up of a wooden back-bar shelf edge with a warm LED glow over unlabeled amber glass bottles

Back-bar shelf lighting that shows the bottles

The usual method is low-voltage LED tape in an aluminum channel with a frosted diffuser, fixed along the front underside of each shelf so light falls onto the bottles below. Puck lights work for short shelves but leave dark gaps between pools of light.

Keep the strip out of sight from the stools; a small lip on the shelf front helps. Pick tape with a CRI of 90 or higher, because low-CRI tape can make whiskey look muddy.

LED tape runs from a driver that converts mains power to 12 or 24 volts. Plug-in drivers suit a home bar. A driver wired to a wall switch is a licensed electrician’s job.

Opinion: one warm white beats color-changing tape, which makes spirits look strange.

Under-counter LED and the bartender’s work light

On the guest side, a strip of LED tape under the overhang of the bar top lights the bar front and the floor near the foot rail. It helps people find the stool at night. Keep it dim and recessed out of view.

On the working side, you need real task light over the prep area. Recessed downlights, small adjustable spots or under-cabinet LED all work. Put it on its own switch so it runs bright for mixing and cleanup while the rest stays dim.

Sinks and ice wells are wet zones. Fixtures directly over them should be rated for damp locations, and decorative lamps belong somewhere else. Gourd lamps are not made for bathrooms or damp spaces, and a bar sink counts.

Color temperature and dimming for evening

Color temperature

For pendants and decorative light, 2200K to 2700K gives the amber glow people expect in a bar. For shelves and the work light, 2700K to 3000K stays warm but reads labels well. At 4000K and above, a bar looks like an office. My view, and it is only a view: keep every source within about 500K of the others, or the room looks patchy.

Dimming

Put each zone on its own dimmer or switch. Then the task light runs full while you make drinks and goes off when you sit down, with the pendants left low.

LED dimming works when the bulb is marked dimmable and the dimmer is rated for LED loads. Mismatched pairs flicker or buzz at the low end, so check the dimmer maker’s compatibility list.

Our gourd lamps have no built-in dimmer. They dim only with a dimmable bulb and a compatible dimmer on the circuit. For layering warm light in a room, see our older post on choosing a gourd lamp for ambient lighting.

Clusters of patterned pendants for atmosphere

A cluster of patterned pendants over the end of a bar or a lounge corner sets the mood of the room. This is where carved gourd lamps earn their place.

Light passes through drilled and carved holes, throwing dotted patterns on the ceiling and walls. Hang three or five at heights staggered by 4 to 8 inches (10-20 cm) and the patterns overlap. Opinion: odd numbers look less stiff than pairs. Where people walk underneath, keep the lowest one at least 7 ft (213 cm) above the floor.

Here is the limit. Patterned gourd pendants give atmosphere. They do not give enough light to mix drinks or read a menu, and I would not sell you one on that promise. Add task lighting. If your budget covers only one fixture over a working bar, buy the task light first.

Our gourd chandeliers and pendant lights come in 13 designs, each $279 with free worldwide shipping, in Natural or White gourd color. The Pineapple Gourd Chandelier is one drilled design. For Turkish hanging lamp styles in general, see our guide to Turkish chandeliers and hanging lamps.

Every gourd differs, so yours will not match the listing photo exactly. Because we can’t take returns, look at the photos and dimensions carefully before ordering.

Small commercial bars: codes, cleaning and buying multiples

A small commercial bar uses the same zones, with extra realities. Our older post on gourd lamps for cafes and restaurants covers dining rooms and patios, so this section sticks to the bar.

Codes and the electrician. Commercial lighting falls under electrical and fire codes, usually with permits and inspection, so hire a licensed electrician. Some inspectors expect listed fixtures; ask what yours requires and settle it before ordering anything handmade, since we can’t take returns. Emergency and exit lighting is a separate requirement.

Cleaning. Bar air carries smoke and cooking grease. Gourd lamps take a dry soft brush only, no water or spray cleaners, so a greasy film can’t be washed off. Keep them away from the kitchen pass and dust them on a schedule.

Durability. Hang pendants over the counter or at least 7 ft (213 cm) up where people walk, out of reach of elbows and coats. A gourd can crack if it hits a hard floor.

Buying multiples. Every piece is $279, and every gourd differs, so a row of six will look related, not identical. If you need an exact match, a handmade gourd is the wrong choice. For multiples, contact us. Production takes 5-7 days and delivery typically 2 weeks, so order well before an opening date. Customs duties, where they apply, are paid by the buyer.

Frequently asked questions

How far apart should pendant lights be over a bar?

A common guideline is 24 to 30 inches (61-76 cm) from the center of one pendant to the center of the next. Keep the end pendants at least 12 inches (30 cm) in from each end of the counter.

How high should pendants hang above a bar counter?

A common guideline puts the bottom of the pendant 30 to 36 inches (76-91 cm) above the counter surface. On a 42 inch bar-height counter, that is about 72 to 78 inches (183-198 cm) from the floor.

What color temperature is best for home bar lighting?

For evening use, 2200K to 2700K suits pendants and decorative lights, and 2700K to 3000K suits back-bar shelves and the work light.

Can gourd pendant lights be the only light over a bar?

No. Gourd pendants are pattern lights with low output, made for atmosphere. They do not give enough light to mix drinks or read a menu, so add a focused task light over the work area.

Are gourd lamps suitable for a small commercial bar?

They can be, with conditions. A licensed electrician installs them after you check what your local code and inspector require. Hang them out of reach and away from sinks and kitchen grease, and dust them with a dry soft brush only. A set of several will not match exactly.

Can I dim a gourd pendant over my bar?

Yes, if you use a dimmable LED bulb and a dimmer rated for LED loads. The lamp has no dimmer of its own, so dimming happens at the bulb and the wall dimmer.

Where next

Settle heights with the hanging guide, then bulbs with the bulb guide. If you want the dotted glow over a bar corner, browse the gourd pendant lights and measure your counter before ordering.

More from the blog

All posts
Choose a gourd colour